Fazendo uma pulseira com nó infinito!

Esse DIY Veio lá do recém-descoberto Made by Girl... eu amei!




DIY: ROPE BRACELET


Hi everyone! It's Jenny Bevlin bringing you another DIY post. I love accessories, but I especially love jewelry! I've noticed lately that I have been buying a lot of bracelets and even making some myself. I find that making my own accessories is very rewarding. It's fun and you will love all the compliments you receive when you say you made it yourself! What you need to make this bracelet:
  • Hot Glue Gun
  • Flat Nose Pliers
  • Scissors
  • Rope trim
  • Jewelry Jump Rings
  • Jewelry Lobster Clasp
  • Jewelry Ribbon Endings


Steps: 

Measure the rope around your wrist leaving about an extra inch longer than your wrist. Cut the rope. Make sure you add a dot of hot glue to the end of the rope you just cut to keep it from unraveling.
Cut 3 more strands the same length as the first strand. Make sure to add a dot of hot glue to ends of the rope each time you cut it.





Lay out the rope as shown in the photo above.


Overlap the rope as shown in the photo above.


Pull the end of the top rope under and up through the bottom rope.


Pull the ends of the rope tight.


Trim the ends so that they are all the same length. Make sure to add hot glue to the ends to keep them from unraveling.


Put the rope ends into the ribbon ending and close with the pliers.



Use the pliers to add the jump rings and lobster clasp.



- post and images by Jenny Bevlin

Share this:

JOIN CONVERSATION

1 comentários:

  1. Olá! Ficou lindo! Ótima dica.

    abraços,
    Luciana
    http://folhasdesonhos.blogspot.com

    ResponderExcluir

Ola! Seu comentario é muito importante para que o blog cresça cada dia mais! Muito obrigada!!!! Qualquer dúvida, envie um email que a gente responde, ok?